The following references should be used to locate the components and connectors for the machine that is being serviced: Electrical System Schematic, Parts Manual and Operation And Maintenance Manual.
The following information is found on the back of the Electrical System Schematic: the “Harness Connector and Component Locations”, the machine profile and area view. The following information explains the use of the information on the back of the System Schematic.
- “Component Locations”
The component location chart uses white circles as location labels in the machine profile and the area view. Alphanumeric letters are used in the columns for the connector location. Alphanumeric characters are used in the machine location column. These identifiers are used in order to indicate the location in the area view.
- “Connector Locations”
The chart for the location of a harness connector uses white circles for the location labels in the general view and the area view. Alphanumeric characters are used in the column for connector locations. These identifiers are used in order to indicate the location in the area view.