|
|
|
|
|
|
| Illustration 1 | g00765496 |
(1) Install the seal in the bearing bore until dimension (A) is 1.00 ± 0.50 mm (0.039 ± 0.020 inch).
- Quantity … 2
(2) Install the seal in the bearing bore until dimension (B) is 1.00 ± 0.50 mm (0.039 ± 0.020 inch).
- Quantity … 2
(3) Torque for locknut … 5900 ± 300 N·m (4352 ± 221 lb ft)
Lubricate the face and the thread of the locknut with 8T-9580 Hydraulic Oil before assembly.
(4) Lubricate the inside diameter and outside diameter of the seals and the ring with clean grease.
(5) Rod assembly
- Diameter of rod … 84.93 mm (3.344 inch)
(6) Bore of cylinder … 120.00 ± 0.10 mm (4.724 ± 0.004 inch)
(7) Bore of head … 85.73 ± 0.030 mm (3.375 ± 0.0012 inch)
Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward.
(8) 163-3748 Sleeve Bearing
- Outside diameter … 85.102 ± 0.011 mm (3.3505 ± 0.0004 inch)
- Inside diameter … 70.23 ± 0.020 mm (2.765 ± 0.0008 inch)
- Install the bearing in the bearing bore. … centered
(9) 163-3751 Sleeve Bearing
- Outside diameter … 95.180 ± 0.013 mm (3.7472 ± 0.0005 inch)
- Inside diameter … 80.2935 ± 0.0435 mm (3.1612 ± 0.0017 inch)
- Install the bearing in the bearing bore. … centered
(10) Lubricate the sealing lip slightly with the lubricant that is being sealed.
(11) Apply 7M-7456 Bearing Mount Compound to the wiper seal groove prior to assembly.