“Synchronize Service Hour Meters” for PL321 In order to perform the “Synchronize Service Hour Meters” function, select the “Service” menu, and “Synchronize Service Hour Meters”…
Category: Product Link 121S/300
The “Digital Input Configurations” should be verified. Once verified, the “Digital Input Configurations” should be changed if required. These values are used to configure the…
The “Preferred Wireless Service Configuration” parameter displays the current configuration for the customers wireless service. This parameter cannot be configured. Table 1 Type of Module…
This section provides information about the reports and messages that are sent from the Product Link system. For information in order to access and change…
Installation Of PL121SR Only Refer to the Systems Operation, Troubleshooting, Testing and Adjusting, “Configuration” for the following information: Preparing a laptop computer to interface with…
Connecting a Computer to the Product Link System Required Software Verify that Product Link has installed the latest flash file. Supported Connections for Hardware The…
Spare Inputs Spare inputs are not supported for the Product Link PL121SR radio. The Product Link PL300 has four additional inputs that can be configured…
Electronic Control Module (ECM) Illustration 1 g01458173 PL300 ECM with 70 pin Wiring Harness Connector Installed The Product Link PL300 is an electronic control module…
Illustration 1 g01325084 The Product Link PL121SR is a communications device that uses satellites in order to transmit information to the following list: Caterpillar, Caterpillar…