Connecting a Computer to the Product Link System Required Software Verify that PL522 and 523 has installed the latest flash file. Supported Connections for Hardware…
Tag: 320
Installation Parameters Configured for PL522 and 523 Ensure that the correct steps have been taken to connect the computer with Cat ET software to the…
Electronic Control Module (ECM) Illustration 1 g02167935 PL522 and 523 ECM The PL522 and 523 are electronic control modules (ECM). The ECM is initially setup…
Illustration 1 g02167864 The PL522 and 523 is a communications device that uses a cellular network in order to transmit information to the following: Caterpillar,…
“Synchronize Service Hour Meters” for PL321 In order to perform the “Synchronize Service Hour Meters” function, select the “Service” menu, and “Synchronize Service Hour Meters”…
The “Digital Input Configurations” should be verified. Once verified, the “Digital Input Configurations” should be changed if required. These values are used to configure the…
The “Preferred Wireless Service Configuration” parameter displays the current configuration for the customers wireless service. This parameter cannot be configured. Table 1 Type of Module…
This section provides information about the reports and messages that are sent from the Product Link system. For information in order to access and change…
Installation Of PL121SR Only Refer to the Systems Operation, Troubleshooting, Testing and Adjusting, “Configuration” for the following information: Preparing a laptop computer to interface with…
Connecting a Computer to the Product Link System Required Software Verify that Product Link has installed the latest flash file. Supported Connections for Hardware The…