Since the pressure specifications, the flow rate, and engine rpm may vary with types and/or suppliers of a work tool, it is very important to…

This calibration procedure is used in order to record the correction data of the proportional solenoid valve for the tool control. This calibration should be…

Note: For this system, parameters that are not shown in the tables do not affect the operation of the work tool. The table shows some…

Note: When additional safety is needed on machines that are equipped with a swing brake solenoid, disconnect the swing brake solenoid so that the swing…

This calibration procedure is used in order to record the correction data of the proportional solenoid valve for the tool control. This calibration should be…

Note: For this system, parameters that are not shown in the tables do not affect the operation of the work tool. Note: Refer to the…

Note: Each of the five work tools have separate values for each parameter that is used. Parameters 201 through 403 are used when the system…

The following procedure is used in order to display the name of the work tool on the monitor. Refer to Illustration 1. Illustration 1 g00881229…

The “machine system” refers to the arrangement of valves and hydraulic lines on the excavator. The systems that are covered by this manual are described…

This procedure is used to enter the service mode of the operator monitor. Illustration 1 g00991623 Illustration 1 is the default screen of the monitor.…