Position the machine on level ground and stop the engine. Release the pressure in the hydraulic system. Refer to Testing and Adjusting, “Hydraulic System Pressure…
Category: 336D
Pressurized System! Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas…
Specification Table 1 “Relief Valve (Pilot) – Test and Adjust” Machine Settings Engine Speed Speed Dial “10” AEC switch…
Note: The engine speed and/or the machine configuration that is used during this test can affect the results of this test. Refer to Testing and…
Specification Table 1 “Cylinder Drift – Check (Loaded Bucket)” Item New Rebuild Service Limit Actual…
Specification Table 1 “Cylinder Drift – Check (Empty Bucket)” Item Cylinder Position New Rebuild Service…
Specification Note: Certain machines will default to “Economy Mode” at machine startup. Change to “High Hydraulic Power Mode” before performing the test procedure. Table 1…
Specification Note: Certain machines will default to “Economy Mode” at machine startup. Change to “High Hydraulic Power Mode” before performing the test procedure. Table 1…
Specification Table 1 “Machine Drift on a Slope – Check” Drift mm (inch) New Rebuild Service Limit…
Specification Note: Certain machines will default to “Economy Mode” at machine startup. Change to “High Hydraulic Power Mode” before performing the test procedure. Table 1…