This calibration procedure is used in order to record the correction data of the proportional solenoid valve for the tool control. This calibration should be…

Note: For this system, parameters that are not shown in the tables do not affect the operation of the work tool. Note: Refer to the…

Note: Each of the five work tools have separate values for each parameter that is used. Parameters 201 through 403 are used when the system…

The following procedure is used in order to display the name of the work tool on the monitor. Refer to Illustration 1. Illustration 1 g00881229…

The “machine system” refers to the arrangement of valves and hydraulic lines on the excavator. The systems that are covered by this manual are described…

This procedure is used to enter the service mode of the operator monitor. Illustration 1 g00991623 Illustration 1 is the default screen of the monitor.…

Table 1 Tool Control System Identification Chart for 320C to 330C     Tool Control System     Number of Control Valves     Slide…

This calibration is used to memorize the power shift pressure for the proportional reducing valve. Be sure to perform this calibration when the proportional reducing…

This function allows the current to the proportional reducing valve to change at a specific rate. This function is used to confirm the activation of…

Illustration 1 g01009662 “Check For Over Current Of Proportional Reducing Valve” Illustration 2 g01009713 Illustration 3 g01009710 “Check For +B Short Of Proportional Reducing Valve”…