Table 1 Required Tools Part Number Description Qty 9U-7400 Multitach Tool Group 1…
Specification Table 1 “Relief Valve (Crossover) – Test and Adjust” Machine Settings Power Shift Pressure 3500 kPa (508 psi) …
Specification Note: Certain machines will default to “Economy Mode” at machine startup. Change to “High Hydraulic Power Mode” before performing the test procedure. Table 1…
Specification Table 1 “Swing Bearing Movement – Measure” Specification For Vertical Movement Of The Swing Bearing Item Specification …
Specification Note: Certain machines will default to “Economy Mode” at machine startup. Change to “High Hydraulic Power Mode” before performing the test procedure. Table 1…
330D, 336D and 340D Excavators Hydraulic System – Swing Motor – Test – Measurement of Case Drain Oil
Specification Note: Certain machines will default to “Economy Mode” at machine startup. Change to “High Hydraulic Power Mode” before performing the test procedure. Table 1…
Table 1 Required Tools Part Number Description Qty 8T-0861 Pressure Gauge (60000 kPa (8700 psi))…
Position the machine on level ground and stop the engine. Release the pressure in the hydraulic system. Refer to Testing and Adjusting, “Hydraulic System Pressure…
Pressurized System! Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas…
Specification Table 1 “Relief Valve (Pilot) – Test and Adjust” Machine Settings Engine Speed Speed Dial “10” AEC switch…